Steel Core Aluminum Stranded Wire Wiring Way

There are many ways of wiring. The best wiring method is the wiring method that is consistent with the project. Therefore, we must integrate several methods according to the project situation.

1. Point to point. Each monitoring point pulls a network cable or a 2-pair four-core type 5 wire. If this point needs to transmit a control signal, the remaining lines of the 2 pairs can be used to transmit control signals.

2.A string. Pull one cable for every four monitoring points, and divide the attachment four routes into a single area before wiring,this network wire passes through the four points in the order of far and near. At each point, the outer skin is removed and a pair of wires are taken out for use by the camera along the way.

3.Centralize first, then send. First, the camera signal is gathered together through the coaxial line, and then transmitted back to the monitoring center through a network wire.

4.Tree structure. Two pairs of 4-core twisted-pair twisted-pair twisted-pair wires are used to pull the signals of the scattered monitoring points to a relatively concentrated place, then it is pulled back to the monitoring center by 4 pairs or large logarithm superscript 5 twisted pair.

The joints for all of the above steel core aluminium strands must be welded,wrap well after welding to prevent water and oxidation.